The part number 297697 is for a Dexter 7K axle.
There is a full bearing kit for this. It's part # BK3-200. It includes the bearings, races, and seals.
Of course, this is not a definite replacement as I could not find exact numbers for your axles. It's very likely that this is the right one, but you should still check the numbers of your current bearings, races, and seals to ensure they match this one's:
Inner bearing: 25580
Inner race: 25520
Outer bearing: 14125A
Outer race: 14276
Seal:... view full answer...
The Keystone Montana is unique in that it has its own set of landing gear legs with three weld stops (tabs) instead of two, and the only option we offer for that is a set of replacement legs:
- Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear # LC178653
- Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear # LC178652
If you use the bottom-most weld stop (tab) you would have to go with these, however, the distance between the top weld stop and second-to-bottom... view full answer...
I don't know the length of the cable used for valves on your Montana so you'll want to measure the length to determine the correct replacement. To make the swap out easy I recommend just unbolting the old valve from the system and then swap in the new valve (without the flanges it comes with). This will make it a much faster swap out and prevent you from having to cut or glue any pipes. I've listed the sizes we currently offer below by cable length:
Black
36" # 34466N4AB36GM
48" # 34466N4AB48GMA
72"... view full answer...
Your 2010 Keystone Montana uses specific landing gear that is special to the Montana. The Lead Leg # LC178653 and Follow Leg # LC178652 are the ones you are needing.
If you find that either the Gearbox # LG-179015 or Motor # LC142178 are bad as well we do have the replacements for them as well. view full answer...
The correct replacement will depend on if you need the Lead Leg or the Follow Leg, but we do have both options available for replacement.
For the Lead Leg, you will need the # LG-177202. For the Follow Leg, you will need the # LG-177201. Both of these will be direct replacements for the landing gear you currently have on your 2010 Keystone Montana. view full answer...
There are two replacement motors for the electric stabilizer jacks, Replacement Electric RV Stabilizer Jack Motor part # LC138445 and Replacement Electric RV Stabilizer Jack Motor part # LC352338. In order to choose the correct replacement motor you simply need to note the color of the support arms. If you support are yellow then you need the Replacement Electric RV Stabilizer Jack Motor part # LC352338 but if the support arms are black then you need Replacement Electric RV Stabilizer Jack... view full answer...
The Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies # LC276602 is the correct replacement for your Venture landing gear. view full answer...
Lippert was unable to identify exactly what you have based on part numbers, but I can still help you find the correct replacement. You will need to check and see where the landing gear is mounted and also measure the black outer tube on your existing leg. If the landing gear is mounted on the inside of the frame rail you need one of the following:
-Replacement Follow Leg for Venture 5th Wheel RV Landing Gear # LC119101 (29-1/2" Measurement)
-Replacement Follow Leg for Venture 5th Wheel... view full answer...